TO UPDATE
In order to update a floor of your building through the Dashboard, you need first selecting the building you want to update the floor on. Then, click on the pencil icon next to the floor you wish to update.

Once clicked, a form similar to the one used to create a floor will appear, only with the values already set up. 

In here, you will be able to modify any of the fields, including uploading a new map of the floor or even adding Custom Fields. Once all changes are made, you'll need to click the Update button so the changes are stored in the system. 

When updating info on a building, you do not lose any information: you keep the calibrations (should there be any), you keep the ID of floors and building, etc.


IMPORTANT ASPECTS TO CONSIDER WHEN UPDATING
  • You will have to maintain the same dimensions if you choose to upload a new floorplan.
  • You will have to make sure that the alignment of the floorplan should be the same as the alignment of the rest of the floors in the building.
  • If you wish to update a floor on a building with multiple floors, please remember to keep the same dimensions, or else the system won't let you update.
  • If you wish to update a floor on a single-floor building and wish to change the dimensions of the floorplan, please note that it takes a while for the system to update and store the information, which could lead to potential incongruences in the dimensions of the floor. If you are faced with this, you can either:
    • contact our support team for help in checking/changing these at support@situm.com
    • if the building only had test calibrations and no vital information in it, you could also erase the building and create it again with new dimensions.



TO ERASE

In order to erase a floor of your building through the Dashboard, you need to first select the building you want to erase the floor from. Then, click on the trash bin icon next to the floor you wish to erase:

Once clicked, you will get a pop-up message, warning you of the consequences of erasing the floor: 

If you still want to delete, click the 'Delete' button and your floor will be deleted.  Please, take into consideration that, if you choose to delete the floor, all calibrations, paths, events and any other types of custom configurations attached to the floor will be permanently deleted.
Therefore, erasing or deleting the floor is only recommended in those buildings where calibration has only been done for testing purposes and no definitive configuration/calibration has been performed.

If you have any doubts regarding erasing a floor, please contact our Support Team at support@situm.com to make a more informed decision.